Hello first I want to make the arrangement that I do not want to offend anyone with my opinion!
What I want to say to the developers of this controller is that they make the brute mistake not to investigate what the requirements for a CFC controller are. But it is not a meat grinder controller. There is an ISO standard and principles that can not be respected if you want users to embrace your idea and enjoy it and ultimately sell it.
I bought this controller and I still can not understand how exactly I can try to use a PROBE. The developer obviously tried to realize one of his ideas, but he did not try to study HOW THIS IS ALREADY WORKED BY 100,000 OTHER DEVELOPERS and works flawlessly .
Nowhere has I found an example with a file that includes a sample of 10 times a PROBE and the code corrected afterwards.
And now, precisely because of this, this controller will go into the trash and my feelings for the developer can predict what they are.
The general functions are described in the manual. The functions outside the manual are not in the service scope, such as macros. If we add these instructions to the manual, it will increase the service cost.
Some users in the forum put forward the needs, in good faith, in the case that I can do it, try to satisfy, but it does not mean that I have the responsibility to meet these needs.
Last edited by stivemaster In 2019-3-15 03:14 Editor
I bought the controller from here and there is no model3 in the software installed in it.When I do something, I know very well how exactly this is done to do it well.Developers have many ways to inform themselves to make a real fancy cnc controller, but they could look at at least to see wikipedia what the mass client would expect from their work.There he writes, according to ISO rs274, what a plc controller should do to be called a cnc controller.
I may have to specify, that as I speak to probe all the time, I am talking about calling the function, during the execution of d code, for correction. Would you give a working example for this,and version of the software you use.
You can add the following program to your G code:
M101 (open probed function)
G91 G01 Z-50.0 F500.0 (Z axis moves down 500mm, in this process, if the probe signal appears, the motion will stop)
M102 (turn off the probed function)
G04P0 (synchronous)
G90 G92 Z0.0 (Set the current workpiece coordinate system Z-axis coordinate to 0.0)
In order to use the above features, your version requires Ver: 2018-10-12-102 or later.
The controller arrived with the software version 89 installed on it. In this version, once it touched, the line runs out and nothing follows. It does nothing then G90G92Z0.
Where can I download the version you recommend and how does it install?
The attachment is the latest version.
Unzip "install" directory to the root directory of the u disk, then insert the u disk into the controller, then power on the controller, and the system will automatically complete the installation.
Hi ytliu
Thanks for all your hard work, and the latest update. Good to see you back on the forum.
I assume all is OK for DDCSV 2.1
Best Regards
picclock
Posted at 2019-3-14 18:07:58
Favorite
Posted at 2019-3-27 18:18:59
Author