manual tool change and probe after M6 command

chrisw

Hi
it took some time but now i found the right settings for manual tool change:
#801 0
#802 mutiple
#803 yes
#805 yes if you want to probe after tool change

i needed an external start button to resume. The internal on the panel didn't work.

the only thing I'm missing now is to control the valve of the probe to clean the tool and the probe.

pakolly

Hi,
Thanks for you message, it helps !
Did you find how to control the valve ?
Did you know where is the programm executed after M6 ? Is it a T.nc somewhere ?
Regards
Pascal

pakolly

I have the same issue with the start panel, it's strange