Thank you. I understood what your idea is. But it seems to me that it is much more convenient to immediately set the tool, with the X and Y axes offset and not only the Y axis.
Since, the tool will be too close to the edge of the sensor and it is likely that when Z is lowered, it may miss the sensor.
Perhaps, it will be convenient for someone.
I think you should make a video about the usefulness of the parameter # 2010.
Можете ли Вы написать инструкцию для пробинга на Русском? Многим русскоязычным пользователям DDCSV, это бы очень помогло.
Также, я хочу узнать Ваше мнение о переводе настроек пробинга. Возможно, по Вашему мнению, некоторые пункты, надо перевести по-другому? (см. файл rus в архиве).
I do not understand why the # 2010 "center of tool plate" parameter is needed?
It seems that he must mix the instrument to the center of the sensor if the edges of the sensor are poorly treated / damaged / contain screw.
But then, a similar parameter is needed for the Y axis. Why only on X?
It is necessary that he determines the edge of X, then he defines the edge along Y (with offset # 2010), and then again on X (with offset # 2010).
What do you think? In my opinion, it turns out illogically.
Posted at 2018-9-8 23:38:27
Author
