Last edited by ytliu In 2018-7-11 18:10 Editor |
1. Increase keyboard support
2. Increase the trial cut (handwheel guide) function
3. Add file editing function
Key mapping description:
X-: LEFT ARROW(â)ãNumeric keypad '4'
X+: RIGHT ARROW(â)ãNumeric keypad '6'
Y-: DOWN ARROW(â)ãNumeric keypad '2'
Y+: UP ARROW(â)ãNumeric keypad '8'
Z-: PAGEDOWNãNumeric keypad '3'
Z+: PAGEUPãNumeric keypad '9'
A-: Numeric keypad '1'
A+: Numeric keypad '7'
the centering operation:F3(Used in conjunction with the MPG axis selection. Only when the MPG axis is selected as X or Y, the corresponding axis performs the centering operation.)
Goto Zero:F5ãNumeric keypad '0'(Used in conjunction with the MPG axis selection. If the MPG axis is selected to be empty, the whole axis will be goto zero. If the MPG axis is selected as X, the X axis will be goto zero.)
Zero:F6ãNumeric keypad 'DEL'(Used in conjunction with the MPG axis selection.If the MPG axis is selected to be empty, the whole axis will be zero. If the MPG axis is selected as X, the X axis will be zero.)
Home:F7(The first press enters the HOME mode. In the HOME mode, press again to perform full axis HOME, or press the corresponding axis selection key, the corresponding axis will perform HOME separately.)
HOME X-axis selection:'X'
HOME Y-axis selection:'Y'
HOME Z-axis selection:'Z'
HOME A-axis selection:'A'
PROBE:F8(The first press enters PROBE mode and presses again to perform the PROBE operation.)
Manual mode switching:F10ãNumeric keypad '*'
Jog distance adjustment:Numeric keypad '5'
Coordinate system selection:'G'ã'0'
START:SCROLL LOCKãNumeric keypad '-'
PAUSE: PAUSE BREAKãNumeric keypad '+'
TRCUT:F11ãNumeric keypad 'ENTER'
Single-stage processing mode:F4(The single-segment mode can be switched while the system is idle. After starting the machining in single-segment mode, the system executes one line each time the start button is pressed.)
Focus TABï¼F9ãNumeric keypad '/'
Uninstall U disk: DELETE