DM500's NC file problem

enjoy_cnc

Hello there,
I'm sorry to have responded to you so long.
1: If the file size is less than 100K, the file will be scanned for structure before processing. The subroutine number must be 0 or not written.
E.g
O000
G54 G90
G01 XYZ
. . . .
or

G54 G90
G01 XYZ
. . . .

2: What is the version number of your application, you can upgrade to the latest version and try it out, or send the video of the handle freeze problem to youtu and send me a link, thank you

enjoy_cnc

Hello there
Can you send the processing files and parameters? Let me check your processing code or you can try another U disk and try again.

enjoy_cnc

Hello there
I tested your processing files and found no stuttering issues;
The possible reasons are as follows:
1: The real-time drawing calculation error is caused by the unknown file size;
Solution:
      First simulate the file and then start processing;
      Turn off the real-time drawing function:
        250: real track paint enable: disable
2: caused by external interference input signal;
        238: IO Filter time: 100 ms

3: U disk read and write problems,
    Replace U disk;

It is recommended to modify the 250 and 238 parameters first and then test!