Continuous movement of Axis A

ytliu · Posted at 2019-7-24 21:21:45

When HOME is executed, it will accelerate to the HOME speed according to the acceleration set by #45-#48. When the zero signal is detected, it will decelerate to stop according to the acceleration set by #263-#266.After the motion stops, the system will retreat at a speed of 50mm/min. When the zero signal disappears, the motion will stop immediately and the mechanical coordinate here will be set to 0.

ytliu · Posted at 2019-7-24 21:11:10

I don't quite understand.

stivemaster · Posted at 2019-7-24 20:52:51

Last edited by stivemaster In 2019-7-24 21:04 Editor

The Problem continue, don't respect acceleration ramp during HOME procedure.
Problem disappeared after pressing EMERGENCY STOP.
When pressing HOME again the problem is back, don't respect acceleration ramp during HOME procedure - AGAIN.

PLEASE MODIFY SOFTWARE Accordingly

awaiting THE NEW software VERSION

ytliu · Posted at 2019-7-24 07:12:40

I tested the HOME operation and found no problems you said.
When HOME is executed, it will accelerate to the HOME speed according to the acceleration set by #45-#48. When the zero signal is detected, it will decelerate to stop according to the acceleration set by #263-#266.

stivemaster · Posted at 2019-7-23 22:33:44

I want to say that I have good feelings and know how hard it is to develop.
I appreciate your reaction, but I will also add that the controller does not observe the overall acceleration ramp when running a home. I want to remind you that there must be only one ramp for the acceleration and this is what the tuner thinks they can perform the engines.

ytliu · Posted at 2019-7-23 16:45:29

Thanks for your suggestion. Due to compatibility, your suggestion cannot be adopted in DDCS.I will adopt your Suggestions in the future controller products.

ytliu · Posted at 2019-7-23 16:38:51

Last edited by ytliu In 2019-7-23 16:39 Editor

Ver:2019-07-23-112 Description:
1. Fixed an error that the file list could not be displayed in the file page without inserting USB stick;
2. Correct the error that the A axis cannot be stopped in the CONT mode in some controllers;(Pending verification)

ytliu · Posted at 2019-7-23 07:04:39

Sorry for the trouble. I will check the program today.

Continuous movement of Axis A

View forum before

TEL

0755-87654321