|
|
Hello kopf
I just watched the video and it is clear that abs Z is cleared in the video, but I used it to send my parameter file, which was not tested on 0107. I suspect now:
1: The parameters in the parameter file are not your latest,
2: 0107 version adds tool magazine T support than the 0804 version. The problem may be here.
So I suspect it is a problem with T code execution.
When encountering T code, he will execute the file:
install-T.nc
I suspect that when executing the original processing file
N30 T1 M06
Triggering the T.nc file caused the Z coordinate offset to change automatically.
If the 90 parameter is <= 1, the execution of T.nc will be skipped. You can check the values of the parameters:
69 =?
89 =?
90 =?
267 =?
# 589 ---- 89 parameter
# 590 --- parameter 90
# 593 Current tool number
; IF # 589 == # 593 GOTO 3;
IF # 590 <= 1 GOTO 3;
IF # 593> # 590 GOTO 3;
IF # 593 <1 GOTO 3;
G04 P0
; M5;
G90 G53 G01 Z # 592 F # 578;
G04 P0
# 1304 = 0; Step 1 off OUT5
# 1305 = 0; Step 2 is OFF6
# 1306 = 0; Step 3 OFF7
# [1304 + # 593-1] = 1; under process
G04 P0
# [806 + [# 516-1] * 4] = # [767 + # 593-1]-# 569; refresh G54 Z
# [804 + [# 516-1] * 4] = # [804 + [# 516-1] * 4] + # [775 + # 593-1]-# [775 + # 589-1]; refresh G54 X
# [805 + [# 516-1] * 4] = # [805 + [# 516-1] * 4] + # [783 + # 593-1]-# [783 + # 589-1]; refresh G54 Y
# 589 = # 593; refresh the current tool number
G04 P0
N3
|
|
Author
isable 1:Enable