Beginners Question - DDCSV2.1 - Standalone CNC Motion Controller - Digital Dream Technology support
View: 4837|Reply: 1
Print Previous Topic Next Topic

Beginners Question

[Copy Link]

1

Threads

1

Posts

7

Credits

Newbie Member

Rank: 1

Credits
7
Jump to the specified floor
Landlord
Posted at 2019-4-12 11:16:07 | Only Author Replies reward |Descending browser |Read mode
Just want to confirm/clear some of my doubts

If i applied the madmodders/pandora firmware,  i should not install the firmware released here ?or can i install the madmodder firmware / followed by the latest firmware released here ?
are they inter compatible ?

If i want to install the firmware released here, i need to switch back to firmware from factory ?
I still have a 2016 unpatched DDCSV 1.1

Thanks
Lam




Reply

Use props Report

8

Threads

333

Posts

1040

Credits

Super Moderator

Rank: 8Rank: 8

Credits
1040
Sofa
Posted at 2019-4-21 06:58:07 | Only Author
I don't think the two will conflict. You can use the official firmware or the pandora firmware. In addition, these firmware can be installed on 1.1.
Reply Support Opposition

Use props Report

You need to log in before you can reply Login | Register now

This forum Credits Rules

Shenzhen Digital Dream Numerical Technology Co., Ltd. support
Adress:507,A Building,Leibo Industry Zone,No. 22 Jinxiu East Road,Kengzi Street,Pingshan district,Shenzhen City,P.R. of China
Phone:13244704799
E-mail:info@ddcnc.com

TEL

0755-87654321

Wchat

Website designed by DigitalDream Technology Support
Quick Reply Back to top Back to list