Different speed with the same code

stivemaster

First I want to thank for the help. I changed the software version from 89 to 106. At the new version there is a difference in the logic of PWM and M3 and a bit difficult to understand the logic, but I get it right. Probe is already working and this video shows the result of it . There is, however, a strange problem. The controller changes the speed of two separate files in which a part of the code is the same. This is the code with which I cut, I just copied the same code and the speed is visibly different.
What can be attributed to this?

stivemaster

Well the problem is visible in the video that I have given. First, the machine cuts the profile and this is a separate file because it may have to be done at the beginning of each profile. Then I run a second file that makes two opposite holes and the same cut off. For the second cut, I just copied the code from the first file. The speed is visibly different.

stivemaster

The Y,Z and A movement of the cut is only with G1.

stivemaster

This forum obviously does not answer all questions.However, I will try again and upload the problem files.
When running file 21, the speed of movement on Y, Z and A is greater than when the file 22 is released. I wonder why this happens?
Additionally, the problem is not only with the speed set by the F and G00 speed and it performs many times at high speed.

stivemaster

What does this parameter mean and where does the manually talk about it?
And I could not understand why G02 and G03 are running at half speed ?

stivemaster

Do you mean that axis that is rotating should I set it as linear?

stivemaster

In my opinion, there is no noticeable difference.
Question:
How ahead in the code looks at the interpreter? And how to speed up successive G1 movements?