What is the future of DDCSv2.1

picclock · Posted at 2019-3-16 17:03:59

Hi ytliu
Thanks for all your hard work, and the latest update. Good to see you back on the forum.
I assume all is OK for DDCSV 2.1
Best Regards
picclock

ytliu · Posted at 2019-3-16 16:49:09

Last edited by ytliu In 2019-3-16 17:00 Editor

The attachment is the latest version.
Unzip "install" directory to the root directory of the u disk, then insert the u disk into the controller, then power on the controller, and the system will automatically complete the installation.

stivemaster · Posted at 2019-3-16 16:29:03

The controller arrived with the software version 89 installed on it. In this version, once it touched, the line runs out and nothing follows. It does nothing then G90G92Z0.
Where can I download the version you recommend and how does it install?

ytliu · Posted at 2019-3-16 08:55:40

You can add the following program to your G code:
M101 (open probed function)
G91 G01 Z-50.0 F500.0 (Z axis moves down 500mm, in this process, if the probe signal appears, the motion will stop)
M102 (turn off the probed function)
G04P0 (synchronous)
G90 G92 Z0.0 (Set the current workpiece coordinate system Z-axis coordinate to 0.0)

In order to use the above features, your version requires Ver: 2018-10-12-102 or later.

stivemaster · Posted at 2019-3-16 07:02:41

I may have to specify, that as I speak to probe all the time, I am talking about calling the function, during the execution of d code, for correction. Would you give a working example for this,and version of the software you use.

ytliu · Posted at 2019-3-15 05:55:59

I am sorry for the confusion you have caused.
Probe mode 3 has a description in http://bbs.ddcnc.com/forum.php?m ... page%3D4&page=2, see 13# and 21# for details. In addition, Will_D helped us write the probing manual (here again thanks to his excellent work), you can download it at http://bbs.ddcnc.com/forum.php?m ... amp;extra=page%3D5.

stivemaster · Posted at 2019-3-15 03:02:48

Last edited by stivemaster In 2019-3-15 03:14 Editor

I bought the controller from here and there is no model3 in the software installed in it.When I do something, I know very well how exactly this is done to do it well.Developers have many ways to inform themselves to make a real fancy cnc controller, but they could look at at least to see wikipedia what the mass client would expect from their work.There he writes, according to ISO rs274, what a plc controller should do to be called a cnc controller.

alexwalex · Posted at 2019-3-15 00:00:54

On my controller "probe" works correctly with all modes (1, and 2, and 3). What does not suit you in work "probe" ?

What is the future of DDCSv2.1

View forum before

TEL

0755-87654321