Hi All. I am trying to connect a solid state relay to my ddcs v3.1 touse on my M3/M5 command. My + trigger wire is on the M3 port and - is on the -COM port on theback of the ddcs. The problem I am having is the trigger voltage is to low. I did test that the solid state relay works by putting 5V battery on itand connecting a 220V bed lamp to the other side. When I trigger the M3 command I can se a voltage difference from 0V to+- 2-3V. I believe from reading the Manuel the output voltage on the trigger shouldbe 10V. Any help on this would help.
| 
Posted at 2024-3-7 19:53:18
Favorite