DM500 /M150 issues

midnightman

I have been having issues ever since i upgraded firmware on the firmware upgrade page
on some firmware versions int the ABS/MACH coordinates it says either INF on X/Y/Zz or it says NAN on X/Y/Z
i have tried every firmware on the firmware upgrade page and still no success.

the controller is a FOINNC M150
and the base is a DM-500
the board inside the controller says DC500 v2.2 on the PCB


thank you in advance

enjoy_cnc

Hello there
The reason for showing INF is that the parameter file setting is missing in the system. You can try to upgrade with the following upgrade package.
If you are not sure which upgrade package to use, please send me a picture of the MAIN page before the upgrade.

The differences between M150 and DM500 are:
1: different brands
2: Different upgrade packages are required

Same point:
Same hardware and software functions

midnightman

im sorry i had gotten confused by the two components. the BOB says "port for DM500" but i have the M150 controller thats where i got confused on the model type and number.

i just flashed the M130-M150 and it worked(default was Chinese but it was easy enough to change by navigating blind haha.

thank you very much for your help. the system is working again

midnightman

I have one more question. do you have an example .nc gcode file for this unit? i cant seem to post process anything that the unit can read.

enjoy_cnc

Hello there
You can use this file to test, this file is also used for my test.

midnightman

I dont see any file, it must not have uploaded

enjoy_cnc

Hello there You can use this file to test, this file is also used for my test.