|
|
|
Hi All. I have a homing issue. only on the Z axis. of my DDCS V3.1. when I home the Z axis it goes in the opposite direction towards the bed. In the parameters 66: Z Axis Home direction it doesn't matter if I make it "negative" or "positive" it still goes down and not up. Only if I change parameters 392: Z Axis DIR Signal Electrical Level to "low" then homing goes up. But now the + and - direction of the Z axis is wrong. Any help would greatly be appreciated. |
|
Posted at 2024-4-5 18:28:27
Favorite