Speed on auto mode

quizzotto

Hi,
i have a problem with the movement speed..
In the HOME mode everything is fine, the speed is the one set in the configuration file.
Instead, in the "goto 0" mode or in the work mode, the speed is locked as in the parameter "Speed of motor start running" (#33)
this happens either in "normal mode" or " g-code mode (#15)
of course  the default  operation speed (#76) is bigger than the (#33)

For example: if "Speed of motor start running" is set to 100 and on g-code i've a F1500 (and set #15 on g-code mode)
on the machine (ddcsv2.1) There is always  "F 100       1500" ... and is soooo slowwww

any help?

thank

ytliu

quizzotto

It works!
It's alive
Thank so much again!

ytliu

Ok, I have already sent you an email.

quizzotto

Hi,
sorry for the delay..

my mail:   s8-s8@hotmail.it

thank so much

ytliu

Can you provide your email address? I will send you a firmware version to see if I can solve your problem.

quizzotto

So,  #77 is set to 5000, #435 and #436 both to 3000.
I can adjust  the F  only when are all stop..
Now I try to reinstall  the firmware and config all from the begin..

edelec

OK #77 #435 #436
Otherwise not sure. Can you adjust F whilst moving?
Richard

quizzotto

Hi,
the G0 speed (#80) is set to 5000..

Max

edelec

What is Section 3  #80 set to? GOTO Zero runs at G0 speed maybe you have it set at 100
Richard