Problem with analog output 0-10V

unkas

Hello everyone, I have DDCSV1.1 mounted with software version 111 and set to a maximum of 24000 rpm, at 12000 rpm I would have to have 5V output and I have 3.8V which speed is less than 12000 rpm. Can this offset be compensated with any parameter or is it an internal problem of the DDCSV ?.

Regards

unkas

I have lowered the maximum revolutions to 18000 and the DDCSV works correctly. My question is does the DDCSV 1.1 have a speed limit? . Let's see if someone could give me some advice to solve this.

Do any of you know how to configure this parameter?

#433 -t0 -s1"PWM rising rate from 0V to 10V" -m6 -min=0.000 -max=65535.000

Regards