Hello everyone, I have a DDCSV1.1 with CW8060 driver, micropasses to 1/10 and my problem is that I can not increase the speed of 8Nw motors to more than 1500 mm / min they get stuck and do not work well.
To be sure the DDCSV is not the problem you can try to reduce the microstep count e.g. to 1/4 (for the driver and the corresponding settings in DDCSV) . If the maximum speed you can reach with this is identical to the 1/10 settting and not higher, it is most unlikely, that the DDCSV is the reason of the problem.
Hello JPoepsel, I have observed that if the axes working on their own reach high voltages but the problem is when you are executing interpolation between axes. The power supplies are 60V one for each axis and its voltage is correct.
Regards
"not reaching heigh RPM" and "step problems when interpolating" is a different story!
Sounds like you have some cross talking between the axis. Shielded cable for the Motor and the STEP/DIR wires may help!
Posted at 2019-2-3 03:45:05
Favorite
Author