Ddcsv2.1 have 256Mb internal memory, is it possible to copy program file from pen drive to internal memory, then disconnect pen drive, and run program (g code) from internal memory instead of pen drive.
Hi edelec,
I connect pen drive then copy test.nc file from directory "udisk-sda1" and paste to "udisk-sda", then i disconnect pen drive and restart controller, but when i go to "udisk-sda", test.nc file disappears.
I am using ver 106, and #120 "U disk partition type" is set to "with partition"
I dont know what i am doing wrong, can you please help.
Thanks
Udisk-sda1 is the USB stick as you realise. The Memory area of the controller is a Nand1-1.
Highlight you memory stick file, "Copy" then highlight mnt "Enter" on mnt, then down to nand1-1 then "Enter". You can now paste and your file is now in the memory. You can also copy some of the .nc files from here back to your memory stick and look at them with a text editor
Hope this makes sense
Yes, it works now, thank you so much.
One minor issue though, "mnt/nand1-1" also contain system files, so it is easy to accidentally delete system file during loading and deleting program, is there a way to create seperate folder in internal memory to avoid this.
Hi ytliu,
Is it possible to make "mnt/nand1-2" directory user writable, to copy g code and run from there?
Currently file disappear from nand1-2 after restart and unable to run file from there.
Also how much free space is available for loading program out of 256mb?
Thanks
DDCSV2.1 uses 32M bytes of SPI FLASH, which is mounted to /mnt/nand1-1/. If you want to use it to store programs, I can provide you with a custom program that will be Create a subdirectory under /mnt/nand1-1/ .
Posted at 2019-3-17 22:03:01
Favorite
Author
Posted at 2019-3-18 07:51:51
