Dual motor on Y axis (slave axis)

joelam

Hello,

We are looking for an offline motion controller that have a full support of dual motors on Y axis.- different step/dir channel and separate home switch for auto-squaring the gantry

(The two motors operate in synchronization when cutting. But when resetting the machine or homing: they are adjusted independently, on their respective limit switches).

Do your DM500 controllers support this function ?


Cordially
Joe

milawka2222

No, not supported. For a long time, special attachments have been developed for this for synchronizing and aligning engines.

Juzer99

Where the Sen Sync V1.3S board can be purchased?