Slave axis

DBS

Hello,

I read almost every information that I found, but can't understood:

I have Y gantry with 2 (two) Motors on it, BUT have "A" axis too.... So I must drive 5 motors.

Is this device SUPPORT SLAVE functionality like DDSCV 4.1 ????

Thank you in advance.

Denis

DBS

Will someone answer?

Largecncrouter

Denis, I checked with the company and you need to connect with your cellphone.

Largecncrouter

Denis,
I'm planning to by a Masso controller, have one small router running very good.
Its expansive but it works.
The DD expert works good but the slave system is only on one sensor, and I need to single sensors for each axis.
For small gantry systems this maybe working, not for me.

Goodluck to connect to them, quick answers

Robert