Title: Z Axis Change its position after breakpoint [Print This Page] Author: rhobhrer Time: 2021-9-2 02:04 Title: Z Axis Change its position after breakpoint Hello.
I've notice a strange situation on Z Axis.
I press SHIFT + Pause to create a breakpoint to continue my work next day.
When I restart the work, I press Pause button to restart the process from last point.
But on my work I"ve noticed that Z Axis is about 0.5 mm down from it's original position and the work shows an irregularity on Z Level.
This not happens when I pause the process (pressing PAUSE) and restarting after sometime. In this case, I do not turn off my CNC and DDCS.
Somebody had this issue?
Regards.
Welcome Digital Dream Technology support (http://bbs.ddcnc.com/)