Title: Digital Dream UC300 controller CONN light always ON and will not connect [Print This Page] Author: justin Time: 2024-2-10 09:01 Title: Digital Dream UC300 controller CONN light always ON and will not connect Last edited by justin In 2024-2-10 09:06 Editor
Hi DD
I not new cnc, but new building a kit cnc and I got and built a 1500x1500 bulkman3d workbee. I have the Digital dream UC300 controller.
Everything was working fine until the other day when I had a problem with the system froze. After power to everything off then back on to re-boot the system. Since then I am unable to communicate the board. The Digital Dream UC300 controller box the CONN light that indicates a connection is now always on BUT it will connect to the PC anymore!!
I have tried everything and still will not connect!!
It's like the board is locked or bricked because the CONN light is stuck on that it is an issue with my controller.
Is there a way to reset this board? just updating the BIN file doesn't work at all!
Welcome Digital Dream Technology support (http://bbs.ddcnc.com/)