Digital Dream Technology support

Title: Problem with g112 [Print This Page]

Author: LUCID Time: 2019-6-14 06:53
Title: Problem with g112
Last edited by LUCID In 2019-6-15 00:25 Editor

Hi
Why DDCSV2.1 does not execute this code
Can someone indicate an error in the code?

N1 %
N2(CAME)
N3
N4(CREATED 06/14/2019 17:57:24)
N5
N6(GRAWEROWANIE - GRAWEROWANIE)
N7 M8
N8 G98 G18 M45
N9 G0 G28 H0
N10(T5 ENGRAVING BIT D 0,1MM)
N11 G0 T0505
N12 G97 S60000 M13
N13 G0 X+14.500 Z+1.000
N14 C0.
N15 G112
N16 G1 F6000
N17 X+5.490 A-2.576
N18 Z-0.200 F200
N19 X+5.998 A-0.892
N20 X+4.562 A-0.459
N21 X+4.165 A-1.773
N22 Z+1.000 F6000
N23 X+4.562 A-0.459
N24 Z-0.200 F200
N25 X+3.126 A-0.025
N26 X+2.618 A-1.709
N27 Z+1.000 F6000
N28 X-2.161 A-2.882
N29 Z-0.200 F200
N30 G2 X-0.445 A-3.721I+0.616
N31 X-1.042 A-5.328I-2.671
N32 X-2.890 A-4.842I-0.783
N33 G1 Z+1.000 F6000
N34 X-3.172 A+0.453
N35 Z-0.200 F200
N36 X-3.620 A+0.973
N37 X-2.772 A+2.524
N38 X-5.264 A+2.879
N39 X-3.620 A+0.973
N40 Z+1.000 F6000
N41 X-2.772 A+2.524
N42 Z-0.200 F200
N43 X-2.092 A+2.427
N44 Z+1.000 F6000
N45 X+1.047 A+3.083
N46 Z-0.200 F200
N47 X+3.039 A+5.326
N48 X+2.575 A+2.900
N49 X+4.929 A+3.647
N50 X+2.937 A+1.404
N51 Z+1.000 F6000
N52 G113
N54 G0 Z50 X0
N55 M1
N56 M5
N57 M9
N58 M46
N59 M30
N60 %
N61

The Z axis is working properly, the X axis is up to a point and it stops. Axis A does not react at all.

ps.
The problem is partially repaired, all the axes are working

Unfortunately, however, it does not work for me G112 code correctly

Author: ytliu Time: 2019-6-15 15:24
Hi，
G112 is a motion command in DDCS,For milling round pockets.

Welcome Digital Dream Technology support (http://bbs.ddcnc.com/)