DDCSV2.1 is not working properly

tahanm

My DDCSV2.1 does not work properly.
I am working with g90 absolute coordinates.
The g0 command destroys the program so I am using g1 instead.
The command g2/3 works only with r. With i,j it gives wrong radius.
While running quit long program after correctly finishing the first pocket I am moving z axis to 5mm it goes there but desides tha it is hiz new 0 and does not doing the second pocket since it engraving in the air.
Please advice
Best Regards
Meir

tahanm

ytliu Posted at 2018-11-7 16:50
Please provide your settings and GCode files.

Get setting file: Go to the /mnt/nand1-1/ directory,  ...

I did not understand the directions you sent
where are  /mnt/nand1-1 and what is U disk?
Best Regards
Meir

tahanm

ytliu Posted at 2018-11-7 16:50
Please provide your settings and GCode files.

Get setting file: Go to the /mnt/nand1-1/ directory,  ...

OK I figured it.
How to attach a file to send you the gcode and the setting
Best Regards
Meir

tahanm

I couldn't figure out how to upload the compressed file to the form.
The is no upload button or menu
Best Regards
Meir

tahanm

HiIt does not allow ZIP file or the setting file
Please send me your mail and I will send it directly to you
Best Regards
Meir