Visualization

ytliu

Can you upload your Gcode? The photo shows that your GCode works in the G59 coordinate system. Does your Gcode use multiple workpiece coordinate systems?

ytliu

Sorry, because the DDCSV processor has limited speed and there is no input device such as a mouse, the system cannot browse the track details, so you don't need to compare it with the PC.

ytliu

For this GCode, what do you think should be drawn?

ytliu

The display of the image is adaptive. After the system runs GCode for the first time, it will record the length, width and height of the tool path. When it is run again, the system will map it to the artboard according to the principle of maximization. Therefore, the position of the zero point on the artboard is not fixed, but related to the running GCode.

ytliu

This installation package allows you to customize the artboard. You need to set #2036 to 1, and then configure the artboard related parameters (#18-#20, #192-#194) according to your actual situation.

The pixels of the artboard are 267*194. It is recommended that you configure the length and height of the artboard in this proportion.

ytliu

If you want to position the zero point in the lower left corner, set #192 and #193 to 0.