|
I have parameter #115 set to 1 (imperial mode) and it seems that G153 behaves very strange.
I have machine coordinant (X0.0) HOME signal at the X- limit so all machine coordinates should be positive but when I execute:
G153 X2.0 F6350. (GOTO MACHINE COORDINATE X2.0 INCH AT 6350 MM/MIN)
The table moves from X1.0(MACH) to X0.9829 (in the negative direction?!?) where it hits the software travel limit but G153 X2.0 should have invoked positive direction motion?
I have not tried G153 in mm mode.
My programs that use G54 coordiants and G01 motion all seem to work well.
|
|