|
I am automating a surface grinder which has vastly different control ratios on its three axes and therefore needs significantly different (mm/s^2) accelerations for each axis.
I got my DDCSV2.1 working well in CONT and MPG modes by tuning M_Ctrl accelerataion and deceleration parameters #45,#46,#47,#263,#264,#265.
Now that I try to run G-Code driven automatic operation I noticed that X,Y,and Z axis all seem to accelerate under the single mm/s^2 acceleration value in parameter #99 (operation acceleration).
Is there any way that I can seperate "operation acceleration" for X,Y, and Z axis while running from G-Code?
For example, I use these axis-specific accelerations which work great in M_Ctrl mode but, for automatic operation, I am forced to set parameter #99 to the least of these (2.0 mm/s^2) which results in a VERY slowly accelerating X-axis:
X: 150 mm/s^2
Y: 7.5 mm/s^2
Z: 2.0 mm/s^2
TOM
|
|