Problem Homing DDCSV3.1

Belwect · Posted at 2021-7-1 00:36:01

Last edited by Belwect In 2021-7-1 00:41 Editor

Problem 1: when executing the Home command, the axes move to the sensors at a speed of 50 mm / min, the parameters are set to 1000 mm/min.The HOME speed does not change.Problem 2: when setting the distance of the axis departure from the sensor, for example, by 10 mm, in the parameters, the axis runs over the sensor, i.e. it works out this rebound in the wrong direction.the current firmware version is 2020-03-06-112NOR

Belwect · Posted at 2021-7-26 12:56:48

The home position is on the negative side. It is not possible to enter negative values. The direction of movement in other operations is correct.

Belwect · Posted at 2021-9-1 20:48:24

No, the problem is not solved. The developers are not responding.

Belwect · Posted at 2021-9-1 20:50:26

The" 0 " of the Z axis is at the top.

Problem Homing DDCSV3.1

TEL

0755-87654321