Full list of DDCSV commands

ytliu

Hi Nikolay81, thank you very much for your work, this code list is very detailed.

M101 and M102 can be added, they are used for probe functions.

ytliu

Ver: 2019-05-27-111 Description:
1. Increase G93(inverse time feed rate mode) support.
In inverse time feed rate mode, an F word means the move should be completed in one divided by the F number minutes.
For example, if the F number is 2.0, the move should be completed in half a minute.

ytliu

Maxx2000:
When the G93 mode is specified, the #5 and #6 settings are ignored.
G93 and G94 belong to the same group of instructions for setting the feed rate mode. G94 to start the units per minute mode. G93 to start the inverse time mode. The default is G94 mode.

Lindo:
Upgrading will not affect the previous features. If you don't use the G93 command, you don't need to upgrade.

ytliu

Hi Lindo,

Ok, I will indicate in the future.

ytliu

Hi Lindo,
1. In the video, I used an input on the RS232 IO expansion board as a toggle switch. You can do this with the USB keyboard F11.
2. If your nc code does some cutting, you can set #253 to line mode; if your nc code is an embossed file, you can set #253 to statue mode;

ytliu

Please check the 24V power supply. The DDCS has a power monitoring module. Usually, the external power supply is lower than 18V, and the system will automatically turn off. At this time, the buzzer will beep until you turn off the power.