Still trying to upload

Nikolay81

Thank you very much for the instruction. Do you speak Russian?

Nikolay81

Will_D Posted at 2018-9-9 19:47
Sorry I don't speak Russian!

The fact that the video, which depicts the work mode3, on YouTube posted a man named Alexey Konev. I thought it was you.

Nikolay81

alexwalex Posted at 2018-9-10 01:15
It was me. You have any question?

Можете ли Вы написать инструкцию для пробинга на Русском? Многим русскоязычным пользователям DDCSV, это бы очень помогло.
Также, я хочу узнать Ваше мнение о переводе настроек пробинга. Возможно, по Вашему мнению, некоторые пункты, надо перевести по-другому? (см. файл rus в архиве).

Nikolay81

alexwalex Posted at 2018-9-10 19:28
Сейчас помочь особо не могу т.к. нахожусь в командировк ...

I do not understand why the # 2010 "center of tool plate" parameter is needed?
It seems that he must mix the instrument to the center of the sensor if the edges of the sensor are poorly treated / damaged / contain screw.
But then, a similar parameter is needed for the Y axis. Why only on X?
It is necessary that he determines the edge of X, then he defines the edge along Y (with offset # 2010), and then again on X (with offset # 2010).
What do you think? In my opinion, it turns out illogically.

Nikolay81

alexwalex Posted at 2018-9-10 20:32
#2010 - величина смещения щупа по X относительно уже измер ...

Я это знаю. Почему только по X? Логичнее было бы сделать и по Y то же. Или я что-то не понимаю?

Nikolay81

Will_D Posted at 2018-9-10 23:54
The user sets the initial Y position before starting the probe so its only X that needs #2010.

По ...

Thank you. I understood what your idea is. But it seems to me that it is much more convenient to immediately set the tool, with the X and Y axes offset and not only the Y axis.
Since, the tool will be too close to the edge of the sensor and it is likely that when Z is lowered, it may miss the sensor.
Perhaps, it will be convenient for someone.
I think you should make a video about the usefulness of the parameter # 2010.