Firmware 2020-03-06-112 bugs

Robchiks

Wrong direction of hominhg on Z axis #66 !
Wrong polarity of Probe signal electrical level #70 !

Robchiks

1.
it doesn't matter.
when start homing motor goes "down" and after  houming motors go "down" too
but on display when you start houming coordinats goes "down" but after goes "up".

Houming work only when (1)#50 Home signal Effective when HOME      value= continue HOME
(3)#118  Z-axis zero signal source select   - I use Z Home

2.
"For Probe signal electrical level #70 , please choose 0= low.
And make sure your wiring is correct, the Probe pin is connected with "+"( red lead), and COM  pin  is connected with "-"(black lead).If you use this kind probe tool, you can try it this way, hope it helps."

it dosn't metter too
Your monitor under "toolpath"indicate on touch Probe "HI" but probe work when in #70 set on "LOW"


do you readme ?

Robchiks

ShaniaDDream Posted at 2021-3-23 18:01
Houming work only when (1)#50 Home signal Effective when HOME      value= continue HOME
(3)#118  Z-a ...

yes I use "Z Home" and it wired on ZHome
so and how it affects the direction of rotation of the motor ?

Robchiks

On controller screen under "toolpath"indicate on touch Probe "HI" but probe work when in #70 set on "LOW" ?