Create a HOME for x, Y, and Z.

ShaniaDDream

Hi, good morning, GotDiesel. Do you mean that your proximity sensor has chosen the signal wiring pin on the terminal block as Home X/Y/Z. If so , please configure the parameter #51 and #116/#117/#118. For #51 Enable limit signal when Home, please choose" 1= disable". And for #116/#117/#118 X-axis/Y-axis/Z-axis zero signal source select, please choose "0=Home signal".
In addition, if your chose the limit signal as your wiring pin, please set it as your real application accordingly, hope it helps.

ShaniaDDream

"the limit doesnt stop travel"-- if your wiring and setting for limit signal is correct, please check your parameter #56 #57 #58, if your Home speed is too big to cause over stroke, then you can try to decrease it.