All motors work perfectly in CONT mode on keypad. If I change Mode to MPG, no axis moves. No matter what axis motor I choose, the x motor makes noises as I turn wheel, but no movement occurs. I assume it must be in perameters, but I have looked all over and can't seem to find anything that fixes the problem.
Last edited by GotDiesel In 2021-2-18 23:50 Editor
The wiring is all wrong inside the MPG. All colors wrong per instructions. All instructions very unclear and very blurry to read. I can't believe we have to rebuild the product to make it work.
On another note. The wiring shows 18 wires to connect to 15 pin connector. My harness only has 17 wires. Many of the colors are not on correct pins and many colors seem to be wire colors picked dont even exist on the wiring code.
This is the worst experience with a new product yet. At least if you expect me to fix your crap, you should supply very clear clean wiring instructions.
Im not sure how Im going to handle this yet, but I will probably keep looking for a better quality controller. At least one that the manufacturer wires per their own instructions.
Posted at 2021-2-16 08:32:44
Favorite
Author