MPG wheel won't move any axis motor - DDCSV3.1 Standalone CNC Motion Controller - Digital Dream Technology support
View: 50|Reply: 4

MPG wheel won't move any axis motor

[Copy Link]

3

Threads

8

Posts

31

Credits

Newbie Member

Rank: 1

Credits
31
Posted at 2021-2-16 08:32:44 | All floors |Read mode
All motors work perfectly in CONT mode on keypad. If I change Mode to MPG, no axis moves. No matter what axis motor I choose, the x motor makes noises as I turn wheel, but no movement occurs. I assume it must be in perameters, but I have looked all over and can't seem to find anything that fixes the problem.



Reply

Use props Report

3

Threads

16

Posts

107

Credits

Registered member

Rank: 2

Credits
107
Posted at 2021-2-16 17:42:36 | All floors
Last edited by Belwect In 2021-2-16 17:58 Editor

For MPG to work, you need 2 power supplies. One for powering the controller, the other for powering the peripheral. You also need to check the wiring of the MPG remote control.
Безымянный.jpg
l7AMp.jpg
Безымянный.jpg
Reply Support Opposition

Use props Report

3

Threads

8

Posts

31

Credits

Newbie Member

Rank: 1

Credits
31
 Author| Posted at 2021-2-17 02:33:42 | All floors
I have two power supplies as shown. Check wiring? It is pre assembled by factory. Are you saying I should open factory plug and check factory wiring?
Reply Support Opposition

Use props Report

3

Threads

16

Posts

107

Credits

Registered member

Rank: 2

Credits
107
Posted at 2021-2-17 14:09:50 | All floors
Open the plug and the remote control itself, ring the wires.
Reply Support Opposition

Use props Report

3

Threads

8

Posts

31

Credits

Newbie Member

Rank: 1

Credits
31
 Author| Posted at 2021-2-18 05:23:25 | All floors
Last edited by GotDiesel In 2021-2-18 23:50 Editor

The wiring is all wrong inside the MPG. All colors wrong per instructions. All instructions very unclear and very blurry to read. I can't believe we have to rebuild the product to make it work.


On another note. The wiring shows 18 wires to connect to 15 pin connector. My harness only has 17 wires. Many of the colors are not on correct pins and many colors seem to be wire colors picked dont even exist on the wiring code.


This is the worst experience with a new product yet. At least if you expect me to fix your crap, you should supply very clear clean wiring instructions.

Im not sure how Im going to handle this yet, but I will probably keep looking for a better quality controller. At least one that the manufacturer wires per their own instructions.

Reply Support Opposition

Use props Report

You need to log in before you can reply Login | Register now

This forum Credits Rules

Shenzhen Digital Dream Numerical Technology Co., Ltd. support
Adress:507,A Building,Leibo Industry Zone,No. 22 Jinxiu East Road,Kengzi Street,Pingshan district,Shenzhen City,P.R. of China
Phone:13244704799
E-mail:info@ddcnc.com

TEL

0755-87654321

Wchat

Website designed by DigitalDream Technology Support
Quick Reply Back to top Back to list