Digital Dream Technology support»Forum › DDCS Series Moiton Controller Technology support › DDCSV3.1 Standalone CNC Motion Controller › DDCS V3.1 & DD8727T4V1

DDCS V3.1 & DD8727T4V1

View number: 4291 | Comments: 4 | Favorite 0

off lights | Prompt: Support keyboard next page<-Left right->

Posts mode

Patmaz

Post Time: 2021-2-2 01:31

Text summary:

Hello. How to connect a stepper motor driver DD8727T4V1 to a controller DDCS V3.1. The driver has a common + input for all PULL and DIR control signals. If you combine all the positive motor control ...

Reply

Robchiks Posted at 2021-3-8 18:17:07

Last edited by Robchiks In 2021-4-30 17:41 Editor

I use this additional devices:https://s.click.aliexpress.com/e/_AEzLIJ (select PNP or NPN depending on how you need)

https://s.click.aliexpress.com/e/_AMemaQ

Richard Posted at 2021-3-1 22:23:16

Last edited by Richard In 2021-3-1 22:33 Editor

Hi.

You can not connect DDCS and DD8727T4V1 directly. But you can connect it with additional electronics. How to do this? I'm not sure because manual for DD8727T4V1 is not well prepare, have lack of information and is not perfect. I don't have this electronic. But i try to show how it can be. See my schema bellow.

You can see and test more by using your hand and multimeter.

Generally I not recommend using DD8727T4V1 with DDCS. If you have some more space in control cabinet buy 4 pcs TB6560 Stepper Driver. It's not much more cost, eg. https://pl.aliexpress.com/item/4000458970475.html but then you have not any problems in work.
Richard

Patmaz Posted at 2021-3-1 01:10:00

I understood it. But I have a common anode stepper motor driver. How to connect it to DDCS?

Robchiks Posted at 2021-2-26 17:42:32

DDCS V3.1 & DD8727T4V1

Text summary:

Reply

TEL

0755-87654321