|
I know people who have a machine running these drivers.
And it works well. But the controller there is not DDCSV.
By the way, I was mistaken. These drivers are digital. But they do not have a connector for tuning through a computer.
But if there is a great desire, you can get everything to work.
You can try to conduct the last experiment, before they throw it away.
Step division 1/8. # 416 = 7000. There are two jumpers inside the driver, J1 and J3. J1 must be opened and J3 closed.
Parameters # 418- # 421 = LOW.
Disconnect the motors from the machine, put the disks on their shafts. The diameter of the disks is equal to the diameter of the motor housing. Disks can be made from anything.
For example, from plywood or plastic. On the disks and on the body you draw serifs. On them you will determine if the motor loses its steps.
Speed ​​is not more than 5000 mm / min.
And you try to run test programs.
Based on the results, sign off.
|
|