Hello guys, I recentelly buy a DDCS V3.1 controller and after 3 months with it I could finished my machine.|
I have a troble with the controller, I can't activate any of 3 outputs, because of that I cant turn on spindle.
The analog signal is ok, I can mesuere it, it's fine. I am using a 1100 ohm relay in the outputs. Even if do does have load (relay) in the output it does not work. The only thing a can see is minimum change in the voltage in the output when referece is 24v, but the voltage changes from 22.7v to 23.9v wich is voltage of my second power supply.
Please could someone help me? I check all conections and configuration, nothing like to be wrong.