Goto Zero

Ricardo

When I move my machine at a speed of 1600 mm / s, it moves perfectly.
If I select "Goto Zero X", only one axis moves 1600 mm / sec without a problem.
Now, if I request "Goto Zero ALL", there is a loss and a step, why does this problem occur?

I already tested with only one drive connected and the problem continues, I realized that the controller could not manage 2 motors or more at the same time at speeds above 400mm / sec.
Any operation that the controller is going to perform above 400mm / sec, there is a loss of steps, the motors can work up to 2400mm / sec. but the controller is no more than 400mm / sec why?

Ricardo

No! I am using individual drivers, one for each engine.

Ricardo

Yes!
Run several tests and the problem continues, the movement of an axis reaches maximum speed, but if you perform a "Goto Zero All" the loss of steps.

Ricardo

I have two sources of 24v one for the controller and another for the motors, I have already performed tests with the machine only with the motors without Spindle and without the inverter and the problem continues.