Hi everyone. There is a problem. mistakenly deleted the settings. from the device. after reboot, the settings were empty. set up everything over again. but now does not show the coordinates of the a-axis. is there any way to restore the device to factory settings.
I have the same problem. the machine starts as usual, but when starting the program from a flash drive, it turns on the spindle, freezes and beeps endlessly. flashing didn't help. did anyone manage to solve the problem?
Dear Sir, please find the attached file.
Decompress it to the root directory of the USB-key.
Insert into the controller, and restart the controller.
System will update it automatically.
Hello, My DDCSV3.1 controller after putting a pendrive is not restarting anymore, it is on the starting screen, is there anything that can be done to recover the system?
Hello, My DDCSV3.1 controller after putting a pendrive is not restarting anymore, it is on the starting screen, is there anything that can be done to recover the system?
cgs Posted at 2021-9-27 22:28
Hello, My DDCSV3.1 controller after putting a pendrive is not restarting anymore, it is on the star ...
Dear Sir, please find the attached file.
Decompress it to the root directory of the USB-key.
Insert into the controller, and restart the controller.
System will update it automatically.
At the same time,only the "insert" file can be stored in the USB flash drive.
Same issue as w_fish. Can jog with the MPG, but since updating to firmware 2020-03-06-112, cannot run a file. Starting even a simple g-code, the spindle starts, then the controller freezes and alarm beeps constant. Have to power cycle the controller to reset it. Changing firmware back didn't fix the issue.
Posted at 2020-10-25 08:48:01
Favorite
Author
Posted at 2020-10-26 09:26:17
