#113 - Hard / Soft

Ricardo

Problem:
# 113 - Arc Interpolation algorithm selection:
0: Hard algorithm
1: Soft algorithm

Because using the "0-Hard algorithm" the Z axis does not move as programmed in the G-Code, the Z axis loses precision, 0.250mm?

Ricardo

you did not understand the problem, using calculation by Hardeware, the Z axis does not go up as programmed is not a loss of pulse, between each hole made the Z axis goes up minus 0.250mm, it is possible to see this difference in the controller display. In Software calculation mode, the Z axis is over correctly.

Thanks for your attention

Ricardo

Sorry I have photos to show here but I do not know additional.

The Z Axis receives the command to decrease to -12mm, controller sends to -16mm, and to rise to 3mm the controller sends to -1.5mm.