Post processor

yehanv71

Hello

DDCSV 2.1........ any assistance with post processor please, i have tried every one in the Fusion360 list and the controller doesnt run. I used the sample file i got with the controller and it works perfect. It was created on Camotics. Also the code looks very different from what i have compared in fusion posts.

Anyone can assist please, PLEASE????, Pretty please??

YCAM-META-DATA: Filename: /home/jcoffland/projects/camotics/svn/trunk/camotics/examples/cat/tiny_cat_outline.svg
YCAM-META-DATA: Timestamp: 2012-01-27 20:11:57.397792
YCAM-META-DATA: Version: 0.5.1

yehanv71

71taa Posted at 2018-7-12 23:18
Using F360 with Fanuc postprocessor w/o subprograms, helical movements should be disabled (it's a ma ...

Hello 71ta

What is meaning of removing o1001, where is this in the result?

Please guide

Thanks

yehanv71

Hi 71taa

I just finished setting up my DDCSV2.1 4 axis controller and managed to successfully edit a post processor for Autodesk fusion 360 that will be compatible with DDCSV1.1, 2.1 and most probably 3.1. Also there is some adjustment to calibrate the controller to the 4 axis so you can get exact degrees and avoid over or under stepping.

Anyone need further assistance with this can contact me if needed.