|
|
Last edited by Evgen In 2018-9-23 00:20 Editor
HI everybody! Thanks for support and improving the device!
Is there somebody faced the trouble - in program (AUTO) mode when G0 command starts(for ex. G0 Y1000) Y axis sometimes misses steps and motor stops, however in the manual fast moving mode(CONT) it was never happened.The speed limits are set the same - 2800mm/min and acceleration/stoping also the same - 40mm/sec2 for both manual and program modes. X and Z axis are working normally.
Dear Ytliu, if it possible can you comment these sections of setting(Motor parameters) please !
It may be I did somthing wrong but when I used Mach the CNC worked right. |
|
Posted at 2018-9-23 00:18:52