Firmware download

Kev0

Hi,
I noticed some weird behaviour in r100. Sometimes the Software Endstop will be triggered but the beeping sound wont be reseted when moving out of it.
And the most annoying thing is that the probing wont work anymore. I straight came from something like r80 (cant remember the correct verion)

Kev0

Could you please increase the maximum halt time for spindle to wait a bit more? 9 seconds is not enough for my spindle to ramp up. Maybe set the limit to something like 20sec to be safe
Regards.

Kev0

@ytliu Thank you very much!
@ Nikolay81 it's not about the braking time. The time to accelerate the spindle is to long. I got a NOWFOREVER E-100 but the settings how to set the ramp up time are not described anywhere. For the D-100 there is a manual but the settings regarding to the rampup are different (D-100 is 1-7 /E-100 defalut 400). So I have to compensate this via the DDCSV.

Btw. really great to have such a good support !!

Kev0

Sorry said it the wrong way. I got a D-100 and there is no manual available.

Why this cant be compensated ? Sure it can.
I set the rampup in DDCSV to 0 wich results in a 0-10V in no time. (Spindle reacts the same way -> ramp slow)
As the spindle runs its ramping curve it just needs more time to reach the desired speed.
In order to have the right cutting speed set the DDCSV to wait a bit longer. Everything is working.

Would be nicer to change the spindle ramping map but this is not possible without a manual .