Firmware download

Nikolay81

alexwalex Posted at 2018-9-22 01:14
Nikolay81, не совсем точный перевод параметров #2001-#2003

По-моему, твой перевод тоже немного корявый.
Посмотри новый перевод - так будет лучше?Ещё в переводе есть места, которые можно более понятно назвать, по твоему мнению?

Evgen

HI everybody! Thanks for support and improving the device!
Is there somebody faced the trouble - in program (AUTO) mode when G0 command starts(for ex. G0 Y1000) Y axis sometimes misses steps and motor stops, however in the manual fast moving mode(CONT) it was never happened.The speed limits are set the same - 2800mm/min and acceleration/stoping also the same - 40mm/sec2 for both manual and program modes. X and Z axis are working normally.
Dear Ytliu, if it possible can you comment these sections of setting(Motor parameters) please !
It may be I did somthing wrong but when I used Mach the CNC worked right.

maxx2000

I thought this was some kind of inexpensive with new features. Thank you. Everything is working.

ytliu

maxx2000 Posted at 2018-9-21 22:56
With the latest firmware(2018-09-07-100).zip), the following happens.
Start  program, and hit the FR ...

I found the reason for this error, because #2028 is a new parameter, after the installation is complete, #2028=0, you need to reset this parameter, such as 10.

ytliu

maxx2000 Posted at 2018-9-21 22:56
With the latest firmware(2018-09-07-100).zip), the following happens.
Start  program, and hit the FR ...

Hi,maxx2000.

Does this fault occur every time? Is your controller 1.1 or 2.1? Can you send me your setting file?

alexwalex

Nikolay81 Posted at 2018-9-21 20:06
Thank you.
Russian translation, now completely finished.
Translated everything that can be translat ...

Nikolay81, не совсем точный перевод параметров #2001-#2003

maxx2000

With the latest firmware(2018-09-07-100).zip), the following happens.
Start  program, and hit the FRO button to adjust the feed rate. Controller locked up.  Locked up & could only reboot to clear it.

Nikolay81

ytliu Posted at 2018-9-21 19:38
the motion planning algorithm has been optimized, so adjusting #396 does not have much impact on mac ...

Thank you.
Russian translation, now completely finished.
Translated everything that can be translated (in some places it is inappropriate to translate, because there is too little space).
Over time, he will improve.
In all subsequent firmware, I ask you to use this translation.

ytliu

the motion planning algorithm has been optimized, so adjusting #396 does not have much impact on machining.

Nikolay81

ytliu Posted at 2018-9-21 06:11
When the line segment in gcode is very short, you may need to adjust the #2 parameter, otherwise p ...

Many thanks.
In which cases, it may be necessary to change the value of parameter # 396?
I set the maximum and minimum values and did not notice the difference.
Can you describe an example, even hypothetical?