|
|
I bought DDCS v.3.1 controller and my machine has 2 motors for Y axes.
My question is:
Can I take signal from Y axes from the controller and connect parallel 2 drivers of 2 motors?
I mean YP+, YP-, YD+,YD- from the controller to connect with Pul+, Pul-, Dir+, Dir- of each of the drivers.
In forums some people share they use 2 relays but I do not know how to connect . How the coil of each relay takes automatically power...
Other people use MASTER / SLAVE connection.
Other people use synchronization board SEN SYNC v1.3s but this product is not available in the market anymore.
Please help me. I cannot find enough info. |
|
Posted at 2023-11-13 04:33:17
Favorite