Radius correction for arcs stops the execution of the programm

alexwalex

I replace in line number 8,31,52.....etc the value of "X-15.702" to "X-20" and controller starts working correctly!

alexwalex

71taa Posted at 2018-7-6 11:32
Still hangs in my case. What correction have you entered for the tool in controller settings?

I run your programm with parameter (284) D1=0 - it works.
Then i set D1=3 (for endmill diameter 6mm) - controller hangs.
Then i replaced in strings 8,31,52,73,94,115,136,157,178 value X to X-20 and controller works correctly with parameter D1=3.

alexwalex

Hi, ytliu !
Got a problem with tool radius compensation:
If i define any nonzero value for the tool 1 radius in the settings of the DDSCV (parameter 284) - this and similar programm not work.

alexwalex

OK, understood. Thanks for the answer. I can hope to fix this problem in the future?