I have had a lot of problems trying to get these 2 codes to work properly.|
I am in absolute metric mode:
and I have to use:
before this code will work:
G1 X62 Y8.907
G2 X58 Y-2 I-4
G2 X53.168 Y-1.677 J2
G3 X6.335 I-23.417 J-36.065
Note that I & J are relative arc centre coordinates BUT G90.1 means
"To go into absolute IJ mode, program G90.1. In absolute distance mode, IJK numbers represent absolute positions in terms of the currently active coordinate system."
Can someone please explain or is this an error in the software.
Any one else managed G02 and G03?