DM500 /M150 issues

midnightman

I have been having issues ever since i upgraded firmware on the firmware upgrade page
on some firmware versions int the ABS/MACH coordinates it says either INF on X/Y/Zz or it says NAN on X/Y/Z
i have tried every firmware on the firmware upgrade page and still no success.

the controller is a FOINNC M150
and the base is a DM-500
the board inside the controller says DC500 v2.2 on the PCB


thank you in advance

midnightman

im sorry i had gotten confused by the two components. the BOB says "port for DM500" but i have the M150 controller thats where i got confused on the model type and number.

i just flashed the M130-M150 and it worked(default was Chinese but it was easy enough to change by navigating blind haha.

thank you very much for your help. the system is working again

midnightman

I have one more question. do you have an example .nc gcode file for this unit? i cant seem to post process anything that the unit can read.

midnightman

I dont see any file, it must not have uploaded