sequence of axis during probing

71taa

/mnt/nand1-1/probe.nc

N2G91G00Z#3
G91G00X#1Y#2

Set the necessary order instead

71taa

denishegemann Posted at 2020-1-13 16:12
thank you, I'am not sure how to edit a file that is located on the controller.

Do I just exchange ...

You can copy this file to your usb drive using F1 (copy)/F2 (paste) sequence from the attached keyboard (use hub). Or edit it right in the controller (F4 as far as I can remember).

This is a plain G-code, so you could add any movements there. If you like to change the order (XY and then Z) - switch G91G00Z#3 with G91G00X#1Y#2, N2 should stay there it is now