Controller suddenly stops responding to manual axis inputs

bluah

Do you know why an axis suddenly becomes unresponsive to inputs (with buttons or MPG) while moving it?

Very frequently, as I jog an axis, it would stop responding to inputs. If I switch to another axis, they will still work, until they, too, suddenly become unresponsive to inputs after moving it around for a while.

The issue is with the controller and not my drivers, as the DRO stops updating too. Pressing reset/e-stop (and or cutting power and restarting) will have it work again.

bluah

Hi,
Thanks for the suggestion. I checked and do not have hard (or soft) limits enabled or installed.