DDCSV 3.1 v3 axis stopper working

CronicPain

Hey guys,

I bought a ddcsv 3.1 v3 only been two weeks, it's been working really good after a while my z axis stopped working
In the screen it shows jogging but nothing happens i changed motors and controllers but nothing, x and y are working properly
I used it with DM542

Thanks!

Will_D

Disconnect the stepper signals from the X or Y axis (known to work  end to end) and connect to the Z stepper driver.

If Z now moves under the X or Y axis control then the problem is not in the DDCSV controller. Else it is!